StarlettePlus-E
StarlettePlus-E
Refrigerated Dryer
SPS 004 – 100
The unprocessed compressed air is wet. After the exit from the post-heater compressor it is 100% Satisfied During cooling in the reservoir and distribution pipelines, the water pair is condensed, forming Water and water aerosolsThe air pressure leads to CorrosionThe growth Microorganisms and formation Oil, acidic condensate The compressor.
For manufacturing enterprises where compressed air is used in automation, such pollution directly affects the Safety, Productivity and Efficiency.
That is why The preparation of the air is necessary.for non-critical applications, the refrigerator is The Ideal Solution.
Refrigerated Dryer
Refrigerated dryers are used Closed-Loop Cooling, lowering the temperature of the compressed air to a level a little above the freezing point, which causes Condensation of waterMost of the scandalized liquid is removed. built-in water separator It is drawn through drenage.
Before the air is pressed. Heat with entrance airto prevent the formation of condensate on the external surface of the subsequent distribution pipelines.
The refrigerator should always be installed together with the General Filters and High Efficiency Coalessent FiltersThis is an effective way of reducing water steam, liquid water and water aerosols for general use of compressed air.
Environmentally safe refrigerated dryersWorking on cold agents with low index GWP according to requirements Regulation on F-Gas (EU 517/2014)It is the best choice to protect. Investment, Climate and Environment.
The advantages
• Refrigerated dryers Parker StarlettePlus-E Based on the modern Aluminium Heat Exchange E-Pack
• Heat exchanger E-Pack has a large air-air heat exchanger for pre-cooling input compressed air and reduced energy consumption
• High efficiency construction E-Pack The refrigeration contains a Lower Power Consumption and uses Less of cold agentsimilar to the drying
• Construction E-Pack Apply Heat exchangers with small pressure losswhich reduces the operating costs
• Heat exchanger E-Pack Equipped High efficiency demister separator from stainless steel to remove the fluid
• In accordance with the requirements of the F-Gas Regulation, all models are used Environmentally safe R513A with low GWPwhich ensures the protection of the environment and reliability of investments
All models are standardized. Digital controllerwhich reflects the temperature of the compressed air, has Untouched emergency contact, Reminders of Service and Timer control of drenage
• Models StarlettePlus-E supported Double power frequency (50 Hz or 60 Hz)
• Optional Energy-saving version (the models SPS026 – SPS100allowing to further reduce energy consumption with partial load by road Cyclical work of the refrigeratorusing the cold stock accumulated in the mass E-Pack
PoleStar Smart-E
Refrigerated Dryer
PSE 120 – 1800
The unprocessed compressed air is wet. After the exit from the post-heater compressor it is 100% Satisfied During the passage through the receiver and the distribution pipeline, the water pair is cooled, leading to the formation of Water and water aerosolsThe air pressure causes CorrosionThe Growth Microorganisms and formation Oil, acidic condensate The compressor.
For manufacturers using compressed air in automatization systems, these pollution directly affect the Safety, Productivity and Efficiency.
That is why Preparation of air is necessary.for non-critical applications Refrigerated Dryer It is the optimal solution.
Refrigerated Dryer
Refrigerated dryers are used Closed-Loop Cooling, lowering the temperature of the compressed air to a level a little higher than the freezing point that causes Condensation of waterMost of the scandalized liquid is removed. built-in water separator It is drawn through drenage.
Before the air is pressed. Heat by entrance flowto prevent the formation of condensate on the external surface of the subsequent distribution pipelines.
The refrigerator should be installed together with General Filters and High Efficiency Coalessent FiltersThis is an effective way of reducing water steam, liquid water and water aerosols in general applications of compressed air.
Environmentally safe refrigerated dryersWorking on cold agents with low index GWP and meet the requirements Regulation on F-Gas (EU 517/2014)It is the best choice to protect. Investment, Climate and Environment.
The advantages
• Refrigerated dryers Parker PoleStar Smart-E Based on the modern Aluminium Heat Exchange SmartPackwhich has a large air-air heat exchanger for pre-cooling input compressed air and reduced energy consumption
• High efficiency construction SmartPackElectronically controlled HGV and innovative Microchannel Condensers The refrigeration contains a refrigeration container with a less consumption capacity and a less 40% less cold agent Compared to traditional solutions
Small loss of pressure in the structure SmartPack and low-consumed power of the refrigerator container makes PoleStar Smart-E Competitive decision Lower operating costs compared to similar
• Electronic controllerwith a sensor screen (from PSE 220They provide the indication of the temperature of the compressed air. Untouched emergency contactReminders of the service, Registration of dataThe history of the accident and Improved Drainage Control
• Lighting indicator The Models (from the Models) PSE 460and High and Low Pressure Manometers (HP/LP) All models from PSE 220
• Distance protocolsPreparation for Industry 4.0 on all models; built-in web server from PSE 220 and IoT-ready from PSE 460
• Function Energy Saving Reduce energy consumption with partial load on the road Cyclical work of the refrigeratorusing the cold stock accumulated in the mass SmartPack
• Ventilator with varied speed (from PSE 460• provide additional savings with partial load and increased stability of the condensation process
• Dryers PoleStar Smart-E Use The appropriate refrigerator compressorsWhat ensure The deadline of serviceLow levels of noise and Energy saving up to 20%. Compared to alternative
All installations are scheduled for Double power frequency 50/60 HzFlexibility of installation thanks to Reverse and Input Pathways Multiple modules (from PSE 750)
• R513A with low GWP Applicable in all models according to the requirements of the regulation F-GasWhat Protecting the long and reduces the risks associated with the use of cold agents with a higher GWP
