A nitrogen generator must be selected for flow, purity, pressure, demand profile and acceptable downtime at the same time. A single catalogue capacity does not define a working system. Oversizing raises capital and energy cost, while undersizing leaves the process short of nitrogen.

Define the process requirement

For every use point, record the application, normal and peak flow, minimum purity and required pressure. Purity should come from the process or product standard. As allowable residual oxygen falls, generator output typically decreases and compressed-air demand rises.

Calculate required flow

Add the measured demand of consumers that can operate together, confirmed losses and a justified allowance. For cyclic loads, build a time profile with peak duration and frequency.

Compare capacity at the same reference conditions. Nm³/h, Sm³/h and actual m³/h may use different reference temperatures and pressures, so the specification must state the normalization standard.

Separate peaks from base load

A brief high draw does not always require a generator sized to the instantaneous peak. A nitrogen receiver can store gas between cycles. Size it from peak flow, draw duration, allowable pressure drop and recovery time.

For variable production, logging actual flow over a representative period is more reliable than adding nameplate values because it reveals simultaneity, cycle duration and leakage.

Specify purity precisely

Supplier capacity must be guaranteed at the required purity, not at an easier operating point. Critical applications may require an oxygen analyzer, alarms, data logging and automatic diversion of off-spec gas. State whether purity is measured at the generator outlet or immediately before the process.

Verify compressed-air supply

PSA and membrane generators consume treated compressed air. Verify available flow, pressure, temperature, pressure dew point, oil and particle levels. Use supplier data at the selected purity to calculate total air demand, including dryers, filters and regeneration.

If the existing compressor station lacks reserve capacity, include a dedicated compressor or network upgrade in the project.

Pressure and boosting

Work backwards from the use point and add losses through pipework, filters, valves and storage. If only one process needs high pressure, a nitrogen booster and local high-pressure storage can be more efficient than raising the pressure of the whole system.

Technology, backup and safety

PSA and membrane systems cover different operating ranges. Compare them across purity, flow, pressure, annual hours, energy, installation conditions and maintenance.

For a critical process, define recovery time and engineer backup such as a standby compressor or generator module, receiver capacity, cylinder manifold or another emergency source. Nitrogen displaces oxygen, so ventilation, risk assessment, safe venting and oxygen monitoring where justified are part of the design.

Information for the specification

  1. Application and duty cycle of each consumer.
  2. Average and peak flow with peak duration.
  3. Minimum purity and residual oxygen limit.
  4. Use-point pressure and allowable pressure drop.
  5. Available compressed-air conditions.
  6. Installation environment and ventilation.
  7. Quality monitoring, alarms and integration.
  8. Permitted downtime, backup and future expansion.

Compare quotations by guaranteed capacity at the same purity, total compressed-air demand, energy use, scope of supply and warranty conditions. That makes the decision process-based rather than driven by the largest catalogue number.

Useful sections

nitrogen generators · nitrogen generation stations · nitrogen generator and cylinder comparison